Differential to common mode conversion due to asymmetric ground via configurations

Renato Rimolo-Donadio, Xiaomin Duan, Heinz Dietrich Brüns, Christian Schuster

Producción científica: Capítulo del libro/informe/acta de congresoContribución a la conferenciarevisión exhaustiva

10 Citas (Scopus)

Resumen

In this paper, the mode conversion in differential links of printed circuit boards and package structures is investigated, taking into account the ground via arrangement and trace length mismatch. The links are modeled using physics-based via and trace models that have been validated previously with full-wave methods and measurements. The very good numerical efficiency of these models allows simulations of different scenarios in minutes rather than hours compared to full-wave tools. It is shown that an asymmetric ground via configuration in the vicinity of a link end can increase the mode conversion in a comparable proportion to the trace length mismatch. The possibility to mitigate the mode conversion by compensating the trace length mismatch with asymmetric ground via configurations and vice versa is also discussed.

Idioma originalInglés
Título de la publicación alojada2009 IEEE Workshop on Signal Propagation on Interconnects, SPI '09
DOI
EstadoPublicada - 2009
Publicado de forma externa
Evento2009 IEEE Workshop on Signal Propagation on Interconnects, SPI '09 - Strasbourg, Francia
Duración: 12 may 200915 may 2009

Serie de la publicación

Nombre2009 IEEE Workshop on Signal Propagation on Interconnects, SPI '09

Conferencia

Conferencia2009 IEEE Workshop on Signal Propagation on Interconnects, SPI '09
País/TerritorioFrancia
CiudadStrasbourg
Período12/05/0915/05/09

Huella

Profundice en los temas de investigación de 'Differential to common mode conversion due to asymmetric ground via configurations'. En conjunto forman una huella única.

Citar esto